HP Aruba JL253A - Page 201

params <ASCII-STR> Name of the SNMPv3 station's parameters file. The
parameters filename configured with params <ASCII-
STR> must match the params <ASCII-STR> value
entered with the snmpv3 params command in Step 6.
The <IP-ADDR> sets the IP address of the destination.
taglist <ASCII-STR> [ASCII-STR] … Specifies the SNMPv3 notifications (identified by one or
more ASCII-STR values) to be sent to the IP address of
the SNMPv3 management station.
You can enter more than one ASCII-STR value. Each
ASCII-STR value must be already associated with the
name of an SNMPv3 notification configuration entered
with the snmpv3 notify command in Step 4.Use a
blank space to separate values.
ASCII-STR
You can enter up to 103 characters in ASCII-STR entries
following the taglist keyword.
[filter {<none | debug | all | not-
info | critical>}]
(Optional) Configures the type of messages sent to a
management station.(Default: none.)
[udp-port < port >] (Optional) Specifies the UDP port to use.(Default: 162.)
[port-mask < mask >] (Optional) Specifies a range of UDP ports. (Default: 0.)
[addr-mask < mask >] (Optional) Specifies a range of IP addresses as
destinations for notification messages.(Default: 0.)
[retries < value >] (Optional) Number of times a notification is retransmitted if
no response is received. Range: 1-255.(Default: 3.)
[timeout < value >] (Optional) Time (in millisecond increments) allowed to
receive a response from the target before notification
packets are retransmitted. Range: 0-2147483647.[Default:
1500 (15 seconds).]
[max-msg-size < size >] (Optional) Maximum number of bytes supported in a
notification message to the specified target. (Default:
1472)
6. Create a configuration record for the target address with the snmpv3 params command.
Syntax:
[no] snmpv3 params <ASCII-STR> user <user_name> sec-model <security_model>
message-processing <security_model> <security_service>
Applies the configuration parameters and IP address of an SNMPv3 management station (from the params
<ASCII-STR> value configured with the snmpv3 targetaddress command in Step 5) to a specified
SNMPv3 user (from the user <user_name> value configured with the snmpv3 user command in Step 2).
If you enter the snmpv3 params user command, you must also configure a security model ( sec_model)
and message processing algorithm ( message-processing).
Chapter 7 Configuring for Network Management Applications 201