If you configure the switch with TimeP as the time synchronization method, then enable TimeP in DHCP mode
with the default poll interval, show timep lists the following:
TimeP configuration when TimeP is the selected Time synchronization method
switch(config)# show timep
Timep Configuration
Time Sync Mode: Timep
TimeP Mode [Disabled] : DHCP Server Address : 10.10.28.103
Poll Interval (min) [720] : 720
If SNTP is the selected time synchronization method, show timep still lists the TimeP configuration even though
it is not currently in use. Even though, in this Example:, SNTP is the current time synchronization method, the
switch maintains the TimeP configuration:
TimeP configuration when TimeP is not the selected time synchronization method
switch(config)# show timep
Timep Configuration
Time Sync Mode: Sntp
TimeP Mode [Disabled] : Manual Server Address : 10.10.28.100
Poll Interval (min) [720] : 720
Syntax:
show management
Helps you to easily examine and compare the IP addressing on the switch. It lists the IP addresses for all time
servers configured on the switch plus the IP addresses and default gateway for all VLANs configured on the
switch.
Display showing IP addressing for all configured time servers and VLANs
switch(config)# show management
Status and Counters - Management Address Information
Time Server Address : 10.10.28.100
Priority SNTP Server Address Protocol Version
-------- ---------------------------------------------- ----------------
1 10.10..28.101 3
2 10.255.5.24 3
3 fe80::123%vlan10 3
Default Gateway : 10.0.9.80
VLAN Name MAC Address | IP Address
------------ ------------------- + -------------------
DEFAULT_VLAN 001279-88a100 | 10.30.248.184
VLAN10 001279-88a100 | 10.0.10.17
30 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
