Parameter Description
Diagnostic
Support
Shows whether the transceiver supports diagnostics:
None
Supported
DOM
Supported
VCT
Supported
Serial Number Serial number of the transceiver
The information in the next three tables is only displayed when the transceiver supports DOM.
Table 33: DOM information
Parameter Description
Temperature Transceiver temperature (in degrees Centigrade)
Voltage Supply voltage in transceiver (Volts)
Bias Laser bias current (mA)
RX power Rx power (mW and dBm))
TX power Tx power (mW and dBm)
The alarm information for GBIC/SFP transceivers is shown in this table.
Table 34: Alarm and error information (GBIC/SFP transceivers only)
Alarm Description
RX loss of signal Incoming (RX) signal is lost
RX power high Incoming (RX) power level is high
RX power low Incoming (RX) power level is low
TX fault Transmit (TX) fault
TX bias high TX bias current is high
TX bias low TX bias current is low
TX power high TX power is high
Table Continued
482 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
