HP Aruba JL253A - Page 508

Syntax:
show debug
Default option is ip-address.
The following shows the output of the show debug command when configured without loggin origin-id.
Output of the show debug command when configured without login origin-id
Debug Logging
Origin identifier: Outgoing Interface IP
Destination: None
Enabled debug types:
None are enabled.
The command logging origin-id hostname will produce the syslog message shown in the following
example.
Syslog message for logging origin-id hostname
Debug Logging
Origin identifier: Hostname
Destination: None
Enabled debug types:
None are enabled.
The command logging origin-id none will produce the syslog message shown in the following example.
Syslog message for logging origin-id none
Debug Logging
Origin identifier: none
Destination: None
Enabled debug types:
None are enabled.
Syntax:
show running-config
The following example shows the output of the show running-config command.
Output of the show running-config command
The command logging origin-id hostname will display the
following:
logging origin-id hostname
The command logging origin-id none will display as the following:
logging origin-id none
508 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08