HP Aruba JL253A - Page 54

Syntax
[no] ntp server
ntp server <IP-ADDR|IPv6-ADDR> [key <key-id>] [oobm] [max-poll <max-poll-val>][min-poll <min-poll-val>][burst | iburst] [version <1-4>]
Parameters/Options
[no]
Removes the unicast NTP configurations on the device.
Subcommands
IP-ADDR
Sets the IPv4 address of the NTP server.
IPV6-ADDR
Sets the IPv6 address of the NTP server.
key <key-id>
Specifies the authentication key.
max-poll <max-poll-val>
Configures the maximum time intervals in power of 2 seconds. Range is 4–17 (e.g., 5 would translate to 2 raised
to 5 or 32).
min-poll <min-poll-val>
Configures the minimum time intervals in seconds. Range is 4–17.
burst
Enables burst mode.
iburst
Enables initial burst mode.
version
Sets version 1–4.
Usage
A maximum of 8 NTP servers can be configured.
Example
switch(config)# ntp
server Allow the software clock to be synchronized by an NTP
time server.
broadcast Operate in broadcast mode.
unicast Operate in unicast mode.
switch(config)# ntp server
IP-ADDR IPv4 address of the NTP server.
IPV6-ADDR IPv6 address of the NTP server.
switch(config)# ntp server <IP-ADDR>
Key Specify the authentication key.
54 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08