show device-profile config
Syntax
show device-profile config
Description
Displays device profile configuration.
Command context
config
Usage
To verify whether tunneled-node is allowed (when “test” is device-profile name):
switch(device-profile)# show device-profile config test
To verify the output when tunneled-node is disabled:
switch(device-profile)# no allow-tunneled-node
switch(device-profile)# show device-profile config test
Example
switch(config)# show device-profile config
Device Profile Configuration
Configuration for device-profile : default-ap-profile
untagged-vlan : 1
tagged-vlan : None
ingress-bandwidth : 100%
egress-bandwidth : 100%
cos : 0
speed-duplex : auto
poe-max-power : Class/LLDP
poe-priority : critical
allow-jumbo-frames : Disabled
allow-tunneled-node: Enabled
Device Profile Configuration
Configuration for device-profile : test
untagged-vlan : 1
tagged-vlan : None
ingress-bandwidth : 100%
egress-bandwidth : 100%
cos : None
speed-duplex : auto
poe-max-power : Class/LLDP
poe-priority : critical
allow-jumbo-frames : Disabled
allow-tunneled-node: Enabled
When tunneled-node is disabled:
switch(config)# show device-profile config
Device Profile Configuration
Configuration for device-profile : default-ap-profile
untagged-vlan : 1
tagged-vlan : None
Chapter 18 Dynamic Segmentation 619
To Next Page
Loading...
