{poe-priority {critical | high | low} |
speed-duplex {auto |auto-10 | auto-100 | ...} |
poe-max-power <Watts> |
allow-jumbo-frames | allow-tunneled-node]
Description
This command is used to create a user-defined profile. A profile is a named collection of port settings applied as a
group. You can modify the default profile, default-ap-profile, but you cannot delete it. You can create four
additional profiles.
The default-ap-profile has the following values:
• untagged-vlan: 1
• tagged-vlan: None
• ingress-bandwidth: 100
• egress-bandwidth: 100
• cos: 0
• speed-duplex: auto
• poe-max-power: class/LLDP
• poe-priority: critical
You can modify these parameters. For example, you can execute no untagged-vlan to create a device profile
with tagged only ports.
Parameters
name
Specifies the name of the profile to be configured. The profile names can be at most 32 characters long.
cos
The Class of Service (CoS) priority for traffic from the device.
untagged-vlan
The port is an untagged member of specified VLAN.
tagged-vlan
The port is a tagged member of the specified VLANs.
allow-tunneled node
Configuration to allow Tunneled Node when device profile is applied on port.
ingress-bandwidth
The ingress maximum bandwidth for the device port.
egress-bandwidth
The egress maximum bandwidth for the device port.
poe-priority
The PoE priority for the device port.
speed-duplex
The speed and duplex for the device port.
714 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
