NOTE: Depending on your server, this page might look slightly different.
Figure 8-8 Remote Serial Console Page
NOTE: The BL c-Class tab is available only on HP Integrity server blades.
The remote serial console is a Java applet that requires Java Plug-in 1.4.2-10 to be installed on
the client system. This applet enables connection to the server serial console over default port
2023. You can configure this port through the Administration > Access Settings page. All data
on this port is encrypted using RC4. The remote serial console provides terminal emulation.
Remote serial console operates with all the operating systems and browsers supported by iLO
2.
NOTE: Pop-up blocking applications prevent remote serial console from running. Disable any
pop-up blocking applications before starting the remote serial console.
The iLO 2 mirrors the system console to the iLO 2 MP local, remote, and LAN ports. One console
output stream is reflected to all of the connected console users. If several different terminal types
are used simultaneously by the users, some users may see unexpected results. Only one of the
mirrored users at a time has write access to the console. Write access is retained until another
user requests console write access. To get console write access, enter Ctrl-Ecf.
To ensure proper operation of the remote serial console, verify the following conditions:
• Your emulator can run the supported terminal type.
• The iLO 2 terminal setting in the applet is a supported setting.
• The operating system environment settings and your client terminal type are set properly.
• All mirrored consoles are of the same terminal type for proper operation. Supported terminal
types are:
Web GUI 117
To Next Page
Loading...
Need help?
General