/map1/swcollection1/swid7
TargetType=PRS FW
VersionString=00.05 UpSeqRev: 09, DownSeqRev: 07
or
</>hpiLO-> show -level all swid*
Firmware Upgrade
Firmware upgrades enhance the functionality of iLO 2.
The MP firmware is packaged along with system, BMC, and FPGA/PSOC firmware. You can
download and upgrade the firmware package from the HP website at http://www.hp.com/go/
bizsupport.
IMPORTANT: When performing a firmware upgrade that contains system programmable
hardware, you must properly shut down any OS that is running before starting the firmware
upgrade process.
Select Download drivers and software, select your server, and follow the directions provided.
After the upgrade, reconnect and log in as user Admin and password Admin (case sensitive).
TIP: Before performing certain iLO 2 functions, verify that you have the supported firmware
version required to carry out the task.
Remote Access Configuration
Integrity iLO 2 supports the use of Telnet and SSH to access the iLO 2 MP command line interface.
Telnet SM CLP Targets
This section describes targets, their properties, and supported verbs necessary to enable or disable
Telnet access to iLO 2.
Target: map1/telnetsvc1
The telnetsvc1 target represents the telnetsvc service provided by map1.
Table 8-43 shows telnetsvc1 target properties.
Table 8-43 telnetsvc1 Properties
Access and ValuesDescriptionProperty Name
Read-only
The following are valid values:
Enabled, Disabled
Shows whether Telnet is enabled or disabled.EnabledState
Read-only
Set to telnet
The protocol this service provides.Protocol
Verbs
start Enables iLO 2 Telnet service.
show Displays information.
stop Disables iLO 2 Telnet service.
help Displays context-sensitive help.
SMASH Server Management Command Line Protocol 165
To Next Page
Loading...
Need help?
General