Resetting iLO 2
To reset iLO 2, run the reset command to the MAP1 target as in the following example:
</>hpiLO-> reset map1
status=0
status_tab=COMMAND COMPLETED
iLO was issued a reset
Text Console Services
This section describes targets, their properties, and supported verbs necessary to implement the
console services in SM CLP.
You can invoke the system console and the MP Main Menu from SM CLP.
Any text console service is represented by a dedicated to it textredirectsap target.
Target /map1/textredirectsvc1 represents iLO 2’s ability to provide text console redirection
service.
Opening the MP Main Menu from SM CLP
This section provides information on how to invoke the MP Main Menu from the SM CLP.
Target: map1/textredirectsap1
The textredirectsap1 target represents the MP Main Menu interface.
Table 8-38 shows textredirectsap1 target properties.
Table 8-38 /map1/textredirectsap1 Properties
Access and ValuesDescriptionProperty Name
Read-only
The value is set to Enabled.
Shows whether the text redirection is enabled.EnabledState
Read-only
The value is set to SMCLP.
Enter SMCLP at the MP Main Menu to
return to the SM CLP interface.
A string sequence used for terminating text
redirection session and returning to SM CLP.
SessionTerminateSequence
Read-only
The value is set to MP Main Menu
Interface.
Description of this text redirection service
access point.
Description
Read-only
The value is set to MP Main Menu
Uniquely identifies this access point.Name
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
start Switch to MP Main Menu.
Opening the System Console Interface from SM CLP
This section provides information on how to open the system console from the SM CLP.
Target: system1/consoles1/textredirectsap1
This target represents the system text console (currently launched through the iLO 2 CO command).
Table 8-39 shows textredirectsap1 target properties.
SMASH Server Management Command Line Protocol 161
To Next Page
Loading...
