If an IP address was obtained through DHCP, an add name request is sent to the DDNS server
if it is enabled and registered.
Command line usage and scripting:
DNS [ [ -server <e|d> ] [ -domain <text> ] [ -name <e|d> ]
[ -register <y|n> ] [ -1ip <ipaddr> ] [ -2ip <ipaddr> ]
[ -3ip <ipaddr> ] ] | [ -all default ] [ -nc ]
-?
See also: LC
FW: Upgrade the MP firmware
This command is only available to authorized HP service personnel.
The MP firmware is packaged along with system, BMC, and FPGA/PSOC firmware. You can
download and upgrade the firmware package from the HP website at http://www.hp.com/go/
bizsupport.
IMPORTANT: When performing a firmware upgrade that contains system programmable
hardware, you must properly shut down any OS that is running before starting the firmware
upgrade process.
Select Download drivers and software, select your server, and follow the directions provided.
After the upgrade, reconnect and log in as user Admin and password Admin (case sensitive).
TIP: Before performing certain iLO 2 functions, verify that you have the supported firmware
version required to carry out the task.
HE: Display help for menu or command in command menu interface
Command access level: Login access
HE displays help for a menu or command.
• If executed from the MP Main Menu, HE displays general information about iLO 2 and those
commands available in the MP Main Menu.
• If executed in command mode, HE displays the MP Help: Command Menu List. HE also
displays detailed help information in response to a topic or command at the help prompt.
Command line usage and scripting:
HE [ -topic | command ] [ -nc ]
-?
ID: System information settings
Command access level: MP configuration access
ID displays and modifies the following:
SNMP contact person Name, telephone, email, and pager number.
Server information Location, rack ID, position, asset tag.
System host name The system host name of the operating system.
NOTE: The system host name information is not retained across
iLO 2 reboots.
Command line usage and scripting:
ID [ { -host [ <text> ] }
| { -person [ -name <text> ] [ -telephone <text> ]
[ -email <text> ] [-pager <text> ] }
Text User Interface 97
To Next Page
Loading...
Need help?
General