Verifying Snap-In Installation and Schema Extension
To verify the installation of snap-ins and schema extension, follow these steps:
1. Run ConsoleOne and log on to the tree.
2. Verify the new classes by opening the Schema Manager from the Tools list.
All the classes related to the HP directory services must be present in the classes list. The
classes are hpqRole, hpqTarget, hpqPolicy, and hpqLOMv100.
Using the LDAP Command to Configure Directory Settings in iLO 2
Use the LDAP Command Menu in the iLO 2 MP TUI to configure iLO 2 LDAP directory settings.
The following is an example of the LDAP command output:
[mp1] MP:CM> LDAP
Current LDAP Directory Configuration:
L – LDAP Directory Authentication : Disabled
M – Local MP User database : Enabled
I - Directory Server IP Address : 192.0.2.1
P - Directory Server LDAP Port : 636
D - Distinguished Name (DN) : cn=mp,o=demo
1 - User Search Context 1 : o=mp
2 - User Search Context 2 : o=demo
3 - User Search Context 3 : o=test
Enter parameter(s) to change, A to modify All, or [Q] to Quit: a
For each parameter, enter:
New value, or
<CR> to retain the current value, or
DEFAULT to set the default value, or
Q to Quit
LDAP Directory Authentication:
E – Enabled
Current > D – Disabled (default)
Enter new value, or Q to Quit: e
> LDAP Directory Authentication will be updated
Local MP User Accounts:
D - Disabled (default)
Current > E - Enabled
Enter new value, or Q to Quit: <CR>
-> Current Local MP User Accounts has been retained
Directory Server IP Address:
Current -> 127.0.0.1 (default)
Enter new value, or Q to Quit: 192.0.2.1
-> Directory Server IP Address will be updated
Directory Server LDAP Port:
Current -> 636 (default)
Enter new value, or Q to Quit: <CR>
-> Current Directory Server LDAP Port has been retained
Distinguished Name (DN):
Current -> cn=mp,o=demo
Enter new value, or Q to Quit: <CR>
-> Current Distinguished Name has been retained
Directory Services for eDirectory 203
To Next Page
Loading...
Need help?
General