Figure 9-3 Schema Results Screen
Management Snap-In Installer
The management snap-in installer installs the snap-ins required to manage iLO 2 objects in a
Microsoft Active Directory Users and Computers directory or in a Novell ConsoleOne directory.
To create an iLO 2 directory using iLO 2 snap-ins, perform the following tasks:
1. Create and manage iLO 2 objects and role objects.
2. Make the associations between iLO 2 objects and role objects.
Directory Services for Active Directory
HP provides a utility to automate much of the directory setup process. You can download the
HP Directories Support for iLO 2 on the HP website at:
http://h20000.www2.hp.com/bizsupport/TechSupport/
The following sections provide installation prerequisites, preparation, and a working example
of directory services for Active Directory.
Active Directory Installation Prerequisites
The following are prerequisites for installing Active Directory:
• The Active Directory must have a digital certificate installed to enable iLO 2 to connect
securely over the network.
• The Active Directory must have the schema extended to describe iLO 2 object classes and
properties.
• The MP firmware must be Version F.01.57 or later.
NOTE: Before performing certain iLO 2 functions, verify that you have the supported
firmware version required to carry out the task. To make sure you have the latest supported
firmware version, see the HP website at http://www.hp.com/go/bizsupport.
• The iLO 2 advanced features must be licensed.
Directory services for iLO 2 uses LDAP over SSL to communicate with the directory servers.
Before installing snap-ins and schema for Active Directory, read and have available the following
documentation:
184 Installing and Configuring Directory Services
To Next Page
Loading...
Need help?
General