Table 8-31 SNMP Settings Page Description
DescriptionField
Choosing Enable or Disable, activates or deactivates the SNMP feature support on
this iLO 2.
SNMP
NOTE: Currently, the SNMP alert feature is only supported on HP Integrity server
blades.
Enter E to enable or D to disable all SNMP alerts.
Enter 1, 2, 3, 4 to configure a destination IP address for SNMP alerts. The default
is blank (unused).
SNMP Alerts
Configure the community string to secure the access to the management information
base (MIB) objects. The default is public.
Community String
Submits the information.Submit
Cancels the action.Cancel
NOTE: If SNMP was disabled earlier and then enabled, you will receive the following message:
Reset MP (XD command option ‘R’) for configuration to take effect.
Click OK and reset iLO 2.
BL c-Class
The Onboard Administrator page (Figure 8-31) is used to facilitate the cabling and initial
installation of servers blade. It also provides a quick view of the enclosure status. You must have
configuration access right to turn the enclosure locator UID LED on or off.
NOTE: Depending on your server, this page might look slightly different.
Figure 8-31 Onboard Administrator
Web GUI 149
To Next Page
Loading...
