HP Integrity BL870c - Target: Map1;Enetport1;Lanendpt1; Target: Map1;Enetport1;Lanendpt1;Ipendpt1; Enetport1 Properties; Lanedpt1 Properties

Table 8-45 enetport1 Properties
Access and ValuesDescriptionProperty Name
Read/write
Boolean values accepted.
Specified if the iLO 2 AutoSense feature is
enabled. If it is disabled, iLO 2 network
speed is set to 10 mb/s.
AutoSense
Read-only
The iLO 2 MP MAC address is formatted
as twelve hexadecimal digits
(10203040506) with each pair representing
one of the six octets of the MAC address.
Represents iLO 2 MP MAC address.PermanentAddress
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
set Sets a property to a specific value.
Target: map1/enetport1/lanendpt1
The lanendpt1 target represents the iLO 2 LAN endpoint settings.
Table 8-46 shows lanendpt1 target properties.
Table 8-46 lanedpt1 Properties
Access and ValuesDescriptionProperty Name
Read-only
The following are valid values:
Enabled, Disabled
Represents the iLO 2 MP LAN state.EnabledState
Read-only
The MAC address is formatted as twelve
hexadecimal digits (010203040506), with each
pair representing one of the six octets of the
MAC address.
Represents the iLO 2 MP MAC address.MACAddress
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
Target: map1/enetport1/lanendpt1/ipendpt1
The ipendpt1 target represents the iLO 2 MP IP endpoint settings.
Table 8-47 shows ipendpt1 target properties.
SMASH Server Management Command Line Protocol 167