HP Integrity BL870c User Manual

Table 8-47 ipendpt1 Properties
Access and ValuesDescriptionProperty Name
Read/write
The value of the property must be expressed
in dotted decimal notation.
iLO 2 MP IP address.IPv4Address
Read/write
The value of the property must be expressed
in dotted decimal notation.
iLO 2 MP subnet mask.SubnetMask
Read-only
The following are valid values:
Static: The iLO 2 MP IP address and subnet
mask were assigned statically.
DHCP: The iLO 2 MP IP address and subnet
mask were acquired using DHCP.
Indicates the configuration method
that resulted in the configuration being
assigned to this ipendpt.
AddressOrigin
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
set Sets a property to a specific value.
Target: map1/dhcpendpt1
The dhcpendpt1 target represents the iLO 2 DHCP client.
Table 8-48 shows dhcpendpt1 target properties.
Table 8-48 dhcpendpt1 Properties
Access and ValuesDescriptionProperty Name
Read-only
The following are valid values:
Enabled: The iLO 2 DHCP client is enabled.
Disabled: The iLO 2 DHCP client is disabled.
Represents the state of iLO 2
DHCP.
EnabledState
Read-only
Set to DHCP.
Textual description of this
protocol endpoint.
OtherTypeDescription
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
start Enables iLO 2 DHCP.
stop Disables iLO 2 DHCP.
Target: map1/dnsendpt1
The dnsendpt1 target represents the iLO 2 DNS client.
Table 8-49 shows dnsendpt1 target properties.
168 Using iLO 2

HP Integrity BL870c Specifications

General

Brand	HP
Model	Integrity BL870c
Category	Server
Language	English