Table 8-49 dnsendpt1 Properties
Access and ValuesDescriptionProperty Name
Read only
The following are valid values:
Enabled: The iLO 2 DNS client is enabled.
Disabled: The iLO 2 DNS client is disabled.
Represents the state of iLO 2 DNS.EnabledState
Read-only
iLO 2 current host name.
Represents the host name currently
assigned to iLO 2.
Hostname
Read-only
Set to DNS.
Textual description of this protocol
endpoint.
OtherTypeDescription
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
Target: map1/enetport1/lanendpt1/ipendpt1/gateway1
The gateway1 target represents the gateway server.
Table 8-50 shows gateway1 target properties.
Table 8-50 gateway1 Properties
Access and ValuesDescriptionProperty Name
Read/write
The value of the property must be expressed
in dotted decimal notation.
Represents the IP address of the gateway
server.
AccessInfo
Read-only
Set to default gateway.
Represents access context (description)
of this access point.
AccessContext
Target: map1/dnsserver1, map1/dnsserver2, map1/dnsserver3
The dnsserver1, dnsserver2, and dnsserver3 targets represent the iLO 2 primary,
secondary, and tertiary DNS servers respectively.
Table 8-51 shows dnsserver1, dnsserver2, and dnsserver3 target properties
Table 8-51 dnsserver1, dnsserver2, dnsserver3 Properties
Access and ValuesDescriptionProperty Name
Read/write
The value of the property must be expressed
in dotted decimal notation.
Represents the IP address of the DNS
server.
AccessInfo
Read-only
Set to DNS server.
Represents access context (description)
of this access point.
AccessContext
Verbs
show Displays information.
help Displays context-sensitive help.
set Sets a property to a specific value.
Target: map1/settings1/dnssettings1
The dnssettings1 target contains iLO 2 DNS settings.
SMASH Server Management Command Line Protocol 169
To Next Page
Loading...
