IMPORTANT: When performing a firmware upgrade that contains system programmable
hardware (FPGA, EFI, PSOC, BMC), you must properly shut down any OS that is running before
starting the firmware upgrade process.
Select Download drivers and software, select your server, and follow the directions provided.
After the upgrade, reconnect and log in as user Admin and password Admin (case sensitive).
TIP: Before performing certain iLO 2 functions, verify that you have the supported firmware
version required to carry out the task.
Licensing
The Licensing page (Figure 8-21) is used to enter a license key to enable the iLO 2 Advanced
Pack features.
NOTE: Licensing keys are not used with cell-based servers, the Lights-Out Advanced KVM
card is used instead. For information on the Lights-Out Advanced KVM card, see Chapter 5
(page 57).
IMPORTANT: A HP ProLiant iLO 2 Advanced Pack license key will not work on an HP Integrity
server, and vice versa.
NOTE: Depending on your server, this page might look slightly different.
Figure 8-21 Licensing Page
138 Using iLO 2
To Next Page
Loading...
