[gstlhpg1] MP:CM> uc -delete Oper -nc
UC -delete Oper -nc
Current User Parameters:
User Login ID : Oper
User Password : ************
User Name : Default Operator
User Workgroup :
User Access Rights : Console access, Virtual Media
User Operating Mode : Multiple
User Enabled/Disabled : Enabled
-> Current User will be deleted
User may be disconnected in this process
-> User Configuration has been updated.
-> Command successful.
[gstlhpg1] MP:CM>
See also: CA, SO, LDAP
WHO: Display a list of iLO 2 connected users
Command access level: Login access
WHO displays the login name of the connected console client users, the ports on which they are
connected, and the mode used for the connection.
• Login name
• Login type (LDAP or local authentication)
• User access rights
• Connection port (local, remote, Telnet, web, SSH)
• IP address (for Telnet, web, SSH)
• Current MP mode that user is in (MA-MP Main Menu, CM-Command menu, LIVE-live
event viewer, VFP-VFP mode)
For LAN and serial console clients, the command displays the IP address. When DNS is integrated,
the host name appears as well.
The local port now requires a login. A user must be logged into the system, or no local port
displays.
Command line usage and scripting:
WHO [ -nc ]
-?
See also: DI, TE
XD: iLO 2 Diagnostics or reset
Command access level: MP configuration access for resetting the iLO 2, console access for all
other XD options
XD performs simple checks to confirm the iLO 2 health and its connectivity status. The following
tests are available:
• iLO 2 Parameter Checksum in NVRAM
• Verify I2C connection (get BMC device ID)
• LAN connectivity test using the ping command
108 Using iLO 2
To Next Page
Loading...
Need help?
General