13
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure a PPP address pool.
ip pool pool-name start-ip-address
[ end-ip-address ] [ group
group-name ]
By default, no PPP address pool
is configured.
3. (Optional.) Configure a
gateway address for the PPP
address pool.
ip pool pool-name gateway
ip-address [ vpn-instance
vpn-instance-name ]
By default, the PPP address pool
is not configured with a gateway
address.
4. (Optional.) Configure a PPP
address pool route.
ppp ip-pool route ip-address
{ mask-length | mask }
[ vpn-instance vpn-instance-name ]
[ vsrp-instance
vsrp-instance-name ]
By default, no PPP address pool
route exists.
The destination network of the
PPP address pool route must
include the PPP address pool.
5. Enter ISP domain view.
domain isp-name N/A
6. Associate the ISP domain with
the configured PPP address pool
for address assignment.
authorization-attribute ip-pool
pool-name
By default, no PPP address pool
is associated.
For more information about this
command, see Security
Command Reference.
7. Return to system view.
quit N/A
8. Enter interface view.
interface interface-type
interface-number
N/A
9. Configure an IP address for the
interface.
ip address ip-ad
d
ress
By default, no IP address is
configured on an interface.
This command is optional when
the PPP address pool is
configured with a gateway
address.
To configure the device as the server (Method 3: Associate a DHCP address pool with an ISP domain):
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure DHCP.
• If the server acts as a DHCP
server, configure the DHCP
server and a DHCP address
pool on the server.
• If the server acts as a DHCP
relay agent, configure the
DHCP relay agent on the server,
and configure a DHCP address
pool on the remote DHCP
server. In addition, you must
enable the DHCP relay agent to
record relay entries, and
configure a DHCP relay
address pool.
For information about
configuring DHCP, see Layer 3
IP Services Configuration Guide.
3. Enter ISP domain view.
domain isp-name N/A