HP MSR Router Series User Manual

14
Ste
p
Command Remarks
4. Associate the ISP domain with
the configured DHCP address
pool for address assignment.
authorization-attribute ip-pool
pool-name
By default, no DHCP address
pool is associated.
For more information about this
command, see Security
Command Reference.
5. Return to system view.
quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Configure an IP address for the
interface.
ip address ip-address
By default, no IP address is
configured on an interface.
Enabling IP segment match
This feature enables the local interface to check whether its IP address and the IP address of the remote
interface are in the same network segment. If they are not, IPCP negotiation fails.
To enable the IP segment match feature:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable the IP segment match
feature.
ppp ipcp remote-address match By default, this feature is disabled.
Configuring DNS server IP address negotiation
Configure DNS server settings depending on the role of your device in PPP negotiation.
• Configuring the local end as the client
During PPP negotiation, the server will assign a DNS server IP address only for a client configured
with the ppp ipcp dns request command. For some special devices to forcibly assign DNS server
IP addresses to clients that do not initiate requests, configure the ppp ipcp dns admit-any command
on these devices.
To configure the local end as the client:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable the device to request
the peer for a DNS server IP
address.
ppp ipcp dns request
By default, a client does not
request its peer for a DNS server
IP address.

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English