HP MSR Router Series User Manual

219
a. Place the modem connected to PC in auto answer mode.
b. Right-click the My Network Places icon and select the Properties option from the menu that
appears.
The Network and Dial-up Connections window appears.
c. Right-click the Make New Connection icon and select the New Connection…option from the
menu that appears.
The Network Connection Wizard window appears.
d. Click Next.
The Network Connection Type dialog box appears.
e. Select the Dial-up to the Internet option, and click Next.
The Internet Connection Wizard dialog appears.
f. Select I want to set up my Internet connection manually, or I want to connect through a local
area network. Click Next.
The Setting up your Internet connection dialog box appears.
g. Select the I connect through a phone line and a modem option. Click Next.
h. Enter the phone number for dialing to the callback server. Click Next.
i. Enter the username user16 and password user16 that you want to use for PPP authentication
when connecting to the server. Click Next.
j. Assign a name to your new connection and follow the instruction to complete the connection
establishment.
k. Open the Network and Dial-up Connections window, right-click the connection you just
created, and select the Properties option in the menu that appears.
The properties setting dialog box appears.
l. Select the Networking tab. In the Type of dial-up server I am calling list, select PPP: Windows
95/98/NT4/2000, Internet. Click
Se
ttings, select the Enable LCP extensions box, clear the
Enable software compression box, clear the Negotiate multi-link for single link connections
box, and click OK.
m. Turn to the Network and Dial-up Connections window. Click the connection icon you just
created. Then, from the menu bar, select Advanced > Dial-up Preferences. In the Dial-up
Preferences dialog box, select the Callback tab and select the No callback option.
n. Double-click the created connection to dial.
Configuration procedure for ISDN mode
On Router C on the dialup side, configure a single dial string.
On Router D on the access side, perform the following tasks:
• Use traditional DDR to establish a connection with Router C through an ISDN PRI interface.
• Configure DDR parameters on a dialer interface.
1. Configure Router C:
# Create dialer group 1 and configure a dial rule for it.
<RouterC> system-view
[RouterC] dialer-group 1 rule ip permit
# Create a local user user1 for authentication, and configure the service type as PPP.
[RouterC] local-user userd class network

HP MSR Router Series Specifications

General

Brand	HP
Model	MSR Router Series
Category	Network Router
Language	English