HPE FlexNetwork 5510 HI Series Layer 3 - Ip Routing Configuration Guide

197
Step Command Remarks
6. Create the BGP IPv6 unicast
address family or BGP-VPN
IPv6 unicast address family
and enter its view.
address-family ipv6
[
unicast
]
By default, the BGP IPv6 unicast
address family or BGP-VPN IPv6
unicast address family is not
created.
7. Enable the router to
exchange IPv6 unicast
routing information with
peers in the specified peer
group.
peer
group-name
enable
By default, the router cannot
exchange IPv6 unicast routing
information with the peers.
Configuring an EBGP peer group
If peers in an EBGP group belong to the same external AS, the EBGP peer group is a pure EBGP
peer group. If not, it is a mixed EBGP peer group.
Use one of the following methods to configure an EBGP peer group:
• Method 1—Create an EBGP peer group, specify its AS number, and add peers into it. All the
added peers have the same AS number. All peers in the peer group have the same AS number
as the peer group. You can specify an AS number for a peer before adding it into the peer group.
The AS number must be the same as that of the peer group.
• Method 2—Create an EBGP peer group, specify an AS number for a peer, and add the peer
into the peer group. Peers added in the group can have different AS numbers.
• Method 3—Create an EBGP peer group and add a peer with an AS number into it. Peers
added in the group can have different AS numbers.
To configure an EBGP peer group by using Method 1 (IPv4):
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance
view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Create an EBGP peer group.
group
group-name
external
By default, no EBGP peer group is
created.
4. Specify the AS number for
the group.
peer
group-name
as-number
as-number
By default, no AS number is
specified.
If a peer group contains peers,
you cannot remove or change its
AS number.
5. Add a peer into the EBGP
peer group.
peer
ip-address [ mask-length ]
group
group-name [
as-number
as-number ]
By default, no peer exists in the
peer group.
The
as-number
as-number
option, if used, must specify the
same AS number as the
peer
group-name
as-number
as-number command.
6. (Optional.) Configure a
description for a peer group.
peer
group-name
description
description-text
By default, no description is
configured for the peer group.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English