HPE FlexNetwork 5510 HI Series Layer 3 - Ip Routing Configuration Guide

222
Figure 59 NEXT_HOP attribute configuration
IMPORTANT:
If you have configured BGP load balancing, the router sets itself as the next hop for routes sent to an
IBGP peer or peer group regardless of whether the peer next-hop-local command is configured.
To configure the NEXT_HOP attribute (IPv4):
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance
view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv4 unicast
address family view or
BGP-VPN IPv4 unicast
address family view.
address-family ipv4
[
unicast
] N/A
4. Specify the router as the next
hop for routes sent to a peer
or peer group.
peer
{ group-name | ip-address }
next-hop-local
By default, the router sets itself as
the next hop for routes sent to an
EBGP peer or peer group.
However, it does not set itself as
the next hop for routes sent to an
IBGP peer or peer group.
To configure the NEXT_HOP attribute (IPv6):
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view.
bgp
as-number N/A
3. Enter BGP IPv6 unicast
address family view.
address-family ipv6
[
unicast
] N/A
4. Specify the router as the next
hop for routes sent to a peer
or peer group.
peer
{ group-name |
ipv6-address }
next-hop-local
By default, the router sets itself as
the next hop for routes sent to an
EBGP peer or peer group.
However, it does not set itself as
the next hop for routes sent to an
IBGP peer or peer group.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English