417
Step Command Remarks
2. Enter routing policy node view.
route-policy
route-policy-name
{
deny
|
permit
}
node
node-number
N/A
3. Match routes whose
destination, next hop, or source
matches an ACL or prefix list.
• Match IPv4 routes whose
destination, next hop, or source
matches an ACL or IPv4 prefix
list:
if-match ip { address |
next-hop | route-source } { acl
acl-number | prefix-list
prefix-list-name }
• Match IPv6 routes whose
destination, next hop, or source
matches an ACL or IPv6 prefix
list:
if-match ipv6 { address |
next-hop | route-source } { acl
acl6-number | prefix-list
prefix-list-name }
By default, no ACL or prefix
list match criterion is
configured.
If the ACL used by an
if-match
clause does not
exist, the clause is always
matched. If no rules of the
specified ACL are matched
or the match rules are
inactive, the clause is not
matched.
The ACL specified in an
if-match
clause must be a
non-VPN ACL.
4. Match BGP routes whose
AS_PATH attribute matches a
specified AS path list.
if-match as-path
as-path-number&<1-32>
By default, no AS path match
criterion is configured.
5. Match BGP routes whose
COMMUNITY attribute
matches a specified
community list.
if-match community
{ { basic-community-list-number |
name
comm-list-name }
[
whole-match
] |
adv-community-list-number }&<1-32
>
By default, no COMMUNITY
match criterion is matched.
6. Match routes having the
specified cost.
if-match cost
value
By default, no cost match
criterion is configured.
7. Match BGP routes whose
extended community attribute
matches a specified extended
community list.
if-match extcommunity
ext-comm-list-number&<1-32>
By default, no extended
community list match
criterion is configured.
8. Match routes having the
specified output interface.
if-match interface
{ interface-type
interface-number }&<1-16>
By default, no output
interface match criterion is
configured.
This command is not
supported by BGP.
9. Match BGP routes having the
specified local preference.
if-match local-preference
preference
By default, no local
preference is configured for
BGP routes.
10. Match routes having MPLS
labels.
if-match mpls-label
By default, no MPLS label
match criterion is configured.
11. Match routes having the
specified route type.
if-match route-type
{
external-type1
|
external-type1or2
|
external-type2
|
internal
|
is-is-level-1
|
is-is-level-2
|
nssa-external-type1
|
nssa-external-type1or2
|
nssa-external-type2
} *
By default, no route type
match criterion is configured.
12. Match IGP routes having the
specified tag value.
if-match tag
value
By default, no tag match
criterion is configured.
To Next Page
Loading...
Need help?
General