67
Tasks at a glance
(Required.) Enabling OSPF
(Optional.) Configuring OSPF areas:
• Configuring a stub area
• Configuring an NSSA area
• Configuring a virtual link
(Optional.) Configuring OSPF network types:
• Configuring the broadcast network type for an interface
• Configuring the NBMA network type for an interface
• Configuring the P2MP network type for an interface
• Configuring the P2P network type for an interface
(Optional.) Configuring OSPF route control:
• Configuring OSPF route summarization
{ Configuring route summarization on an ABR
{ Configuring route summarization on an ASBR
{ Configuring discard routes for summary networks
• Configuring received OSPF route filtering
• Configuring Type-3 LSA filtering
• Configuring an OSPF cost for an interface
• Configuring the maximum number of ECMP routes
• Configuring OSPF preference
• Configuring OSPF route redistribution
{ Redistributing routes from another routing protocol
{ Redistributing a default route
{ Configuring default parameters for redistributed routes
• Advertising a host route
(Optional.) Tuning and optimizing OSPF networks:
• Configuring OSPF timers
• Specifying LSA transmission delay
• Specifying SPF calculation interval
• Specifying the LSA arrival interval
• Specifying the LSA generation interval
• Disabling interfaces from receiving and sending OSPF packets
• Configuring stub routers
• Configuring OSPF authentication
• Adding the interface MTU into DD packets
• Configuring a DSCP value for OSPF packets
• Configuring the maximum number of external LSAs in LSDB
• Configuring OSPF exit overflow interval
• Enabling compatibility with RFC 1583
• Logging neighbor state changes
• Configuring OSPF network management
• Configuring the LSU transmit rate
• Enabling OSPF ISPF
• Configuring prefix suppression
• Configuring prefix prioritization
• Configuring OSPF PIC
• Configuring the number of OSPF logs
To Next Page
Loading...
