EDGE Pro Ti CNC Instruction Manual 807660 119
Maintenance and Diagnostics
Operator control panel board (141058)
Table 22 Pinouts for J1 to J16
Pin no. Signal Pin no. Signal Pin no. Signal
J1 Station 2 J7 To utility PCB
33 Logic +5 V
1 Auto select 2 1 Start 34 Logic +12 V
2 Logic ground 2 Stop
J9 Raise 2
3 Manual select 2 3 Manual 1 Logic ground
4 Not used 4 Forward on path 2 Raise torch 2
J2 Jog potentiometer
5 Backward on path
J10 Raise 1
1 Logic ground 6 Joystick +Y 1 Logic ground
2 Analog (jog speed) 7 Joystick -Y 2 Raise torch 1
3 4.096 V Reference 8 Joystick -X
J11 Manual
J3 Station 1
9 Joystick +X 1 Logic ground
1 Auto select 1 10 Logic ground 2 Manual switch
2 Logic ground 11 Logic ground
J12 Lower 2
3 Manual select 1 12 Not connected Front panel
ID 1
1 Logic ground
4 Not used 13 Ground Front panel ID 0 2 Lower torch 2
J4 Cut potentiometer
14 Not connected Front panel
ID 1
J13 Lower 1
1 Logic ground 15 Logic ground 1 Logic ground
2 Analog (cut speed) 16 Logic ground 2 Lower torch 1
3 4.096 V Reference 17 Not connected Front panel
ID 2
J14 Forward
J5 Stop
18 Auto select 1 1 Logic ground
1 Logic ground 19 Manual select 1 2 Forward on path
2 Stop switch 20 Raise torch 1
J15 Back
J6 Start
21 Lower torch 1 1 Logic ground
1 Logic ground 22 Auto select 2 2 Backward on path
2 Start switch 23 Manual select 2
J16 Power switch
J8 Joy stick
24 Raise torch 2 1 Logic +12 V
1 Up 25 Lower torch 2 2 MB On/Off 1
2 Down 26 Station enable LED1 3 MB On/Off 2
3 Left 27 Station enable LED2 4 Logic ground
4 Right 28 Motherboard On/Off 1
5 Logic ground 29 Motherboard On/Off 2
6 Logic ground 30 Cut speed
31 Jog sped
32 4.096 V Reference