EDGE Pro Ti CNC Instruction Manual 807660 51
Installation
X and Y axis configuration
X and Y axis configuration
To configure the X and Y axes, first decide which axis on the table will be the X axis and where the home position will be.
Next, define the X/Y orientation and home position in Phoenix software (Setups > Password > Machine Setups) to match
the configuration you want on the table. The definition of the axes orientation and home position in software and on the
table must agree so the system can execute the part programs as expected.
Figure 13 Example of a shape cutting system configured with an EDGE Pro Ti CNC
The operator console
The EDGE Pro Ti comes with a 2-station operator console that allows you to operate two cutting torches or stations.
The operator console allows you to:
• Start and stop the cutting program.
• Switch to manual mode
• Manually jog the torch with the joystick
• Jog forward or backward on path
• Adjust the jog and cutting feed rates
• Activate or deactivate the 2 cutting stations
The device I/O for the operator console are assigned to Input and Output 129 and higher, as listed in Table 5.
EDGE Pro Ti CNC
CNC control panel
X-
Y-
Y+
X+
Table origin and
Home position
(0,0)
To Next Page
Loading...
Need help?
General
