30 EDGE Pro Ti CNC Instruction Manual 807660
Specifications
Overview
Operator console
The EDGE Pro Ti operator control panel can control two cutting stations. Additional control panels, not manufactured by
Hypertherm, may be installed by the table manufacturer to control oxyfuel, markers, ventilation systems, and other
devices. For more information about an optional control panel, refer to the manual provided by the table manufacturer.
Oxyfuel torch
Automated cutting systems can also be configured with oxyfuel torches with or without an oxygen height control (OHC).
If the Hypertherm Sensor™ OHC is configured in your system, refer to the Sensor OHC manual (MANU–0044) for
information about installation and operation.
For more information about any other oxyfuel torch, refer to the manual supplied by the table manufacturer.
Marker
A marker can be any device or process that marks a plate rather than piercing or cutting it. If the Hypertherm ArcWriter
®
is configured in your system, refer to the ArcWriter manual (802520) for information about installation and operation. Any
HPR plasma system can also be used for marking. For more information, see the appropriate HPR manual.
For other devices or processes, refer to the appropriate manual.
Overview
The EDGE Pro Ti is a PC-based CNC and uses Hypertherm’s Phoenix software to control one or more cutting or marking
stations.
The EDGE Pro Ti CNC has up to 4 integrated servo drive amplifiers, a two-station operator console, a 15-inch
touchscreen, wireless communication, and the Phoenix application software.
EDGE Pro Ti features can be expanded with the addition of networking to download part programs or remote diagnostic
utilities.
Figure 4 Front view of the EDGE Pro Ti CNC
2-Station operator console
Touchscreen
To Next Page
Loading...
Need help?
General
