EDGE Pro Ti CNC Instruction Manual 807660 93
Section 3
Operation
Operating the CNC
Phoenix software runs on the Hypertherm computer numerical controls (CNCs) and supports either a touch screen or
LCD display with a USB-connected keyboard and mouse for entering information and navigating the software. For more
information, see the Phoenix Software Operator’s Manual.
For more information about the components of your cutting system that are supplied by your table manufacturer, refer to
the manuals supplied by the manufacturer.
Touch screen LCD
The Phoenix software is designed for touch screens with 1024 x 768 resolution and a 4:3 aspect ratio. When your CNC
is equipped with a touch screen, you can enter data into the software by touching the window controls and fields. Any
field that requires data input automatically displays an onscreen keypad when you touch it.
Screen navigation
The keys located at the bottom of the screen in the software are called soft keys. The soft keys correspond to function
keys on a PC keyboard. OK and Cancel soft keys let you save or cancel changes that you make in a screen.
For more information, refer to the Phoenix Software Operator’s Manual (806400).
To Next Page
Loading...
Need help?
General
