IBM V7000 User Manual

344 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
If you want to migrate the data from the external volume (that is being imported) to existing
IBM Flex System V7000 Storage Node MDisks, choose an existing destination storage pool.
Only pools with sufficient free capacity are listed in Step 2 (Figure 8-36). The actual data
migration begins after the MDisk was imported successfully.
Figure 8-36 Import Wizard - step 2 of 2
You can check the migration progress in the Running Tasks status indicator as also shown in
Figure 8-33 on page 342 or by clicking Pools  System Migration.
After the migration has completed, you can find the volume in the chosen destination pool
(Figure 8-37).
Figure 8-37 Volume migrated to destination pool
The name of the Volume is determined by the IBM Flex System V7000 Storage Node MDisk
Import process, and you might want to rename the Volume to a more adequate name that
indicate the purpose of the Volume. The volume can be renamed by right-clicking the volume
and click Rename.

IBM V7000 Specifications

General

Model	IBM Storwize V7000
Storage Type	Hybrid Flash Array
Maximum Capacity	1.2PB
RAID Levels	0, 1, 5, 6, 10
Connectivity	8 Gbps Fibre Channel, 16 Gbps Fibre Channel, 1 Gbps iSCSI, 10 Gbps iSCSI
Management	Command-line interface (CLI), Graphical user interface (GUI)
Form Factor	2U
Drive Bays	12
Maximum Raw Capacity	1.2PB
Operating System Support	AIX, HP-UX, Linux, VMware, Windows
Data Reduction Features	Real-time Compression, Deduplication
Drive Types	SSD, HDD
Scalability	Scale-up (drive enclosures) and scale-out (clustering) capabilities