IBM V7000

488 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
Figure 11-33 Submit Zoneset Configuration
A this point you have activated the Zoneset with the new Zone, now you have to complete the
same procedure in the other CN4093 that is in your chassis.
Creating FCoE zoning with CLI
By creating a zone that will include PWWNs of the host (Compute Node 11 and the storage
controller) for IBM Flex System V7000 Storage Node, the two end points will be able to
connect and storage can be accessed by the O/S platform residing on Compute Node 11.
The zoning steps are exactly the same as when using the GUI and are very much the same
as is used on FC zoning:
򐂰 Create Zone
򐂰 Create Zoneset
򐂰 Activate Zoneset
Example 11-5 shows, from the ISCLI, creating a zone and populating it with PWWNs from
Compute Node 11 and each canister of IBM Flex System V7000 Storage Node.
Example 11-5 Creating Zone and Zoneset
Router(config)#zone name FSV7K_N11---------------------------------> Create Zone
Router(config-zone)#
member pwwn 50:05:07:68:05:04:02:50
Router(config-zone)#member pwwn 50:05:07:68:05:04:02:51
Router(config-zone)#member pwwn 10:00:5c:f3:fc:6e:30:01--------> Add PWWN members
Router(config-zone)#show zone