IDEC MICRO/I HG1P-ST32 Series User Manual

3 Uploading
24-22 WindO/I-NV4 User’s Manual
3.2 Upload Dialog Box
This section describes the settings and buttons of the Upload dialog box.
■ Project Name
The project is saved with the currently displayed name. To change the project name, enter a new name for the file.
The maximum number is 50 characters.
■ Type Number
Displays the type number selected in project data downloaded to the MICRO/I.
■ Modified
Displays the time that project data downloaded to the MICRO/I was last saved in WindO/I-NV4.
■ Location
Specifies the location for saving uploaded project files.
Click to display the Browse folders dialog box. Select the location for saving, then click OK.
■ Upload files used in this project from the External Memory Device
To upload files located on an external memory device inserted in the MICRO/I that are used by the project together
with project data, select the file to be uploaded from the following.
Recipe Files, Picture Files, Sound Files
*1
, Custom Web Page Files
■ Upload
Starts uploading of project data.
■ Cancel
Stops uploading of project data.
*1 This is applicable for models with an audio interface only.
You cannot use the following characters in the project name.
\ / : * ? " < > |

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English