WindO/I-NV4 User’s Manual 30-15
3 Analog I/O Modules
30
Expansion Modules
â– Signal Type
The signal type that can be set differs according to the analog I/O module model. Select the analog I/O module that
corresponds to the user application and set the signal type. The signal type is the type of analog input to measure.
There are 24 signal types for the analog inputs, which are detailed as follows.
YES: Supported, NO: Not supported
*1 Channels that are set to unused are not scanned.
The circuit is setup the same as when signal type: 0 to 10 V is selected.
0 is always stored in the analog data storage data registers for channels that are set to unused.
Signal Type
FC6A-
J2C1
FC6A-
J4A1
FC6A-
J8A1
FC6A-
J4CN1
FC6A-
J4CH1Y
FC6A-
J8CU1
FC6A-
L06A1
FC6A-
L03CN1
Unused
*1
YESYESYESYESYESYESYESYES
0 to 10 V YES YES YES YES NO NO YES YES
-10 to +10 V YES YES YES YES NO NO YES YES
0 to 20 mA YES YES YES YES NO NO YES YES
4 to 20 mA YES YES YES YES NO NO YES YES
Type K thermocouple NO NO NO YES YES YES NO YES
Type J thermocouple NO NO NO YES YES YES NO YES
Type R thermocouple NO NO NO YES YES YES NO YES
Type S thermocouple NO NO NO YES YES YES NO YES
Type B thermocouple NO NO NO YES YES YES NO YES
Type E thermocouple NO NO NO YES YES YES NO YES
Type T thermocouple NO NO NO YES YES YES NO YES
Type N thermocouple NO NO NO YES YES YES NO YES
Type C thermocouple NO NO NO YES YES YES NO YES
Pt100 NO NO NO YES NO NO NO YES
Pt1000 NO NO NO YES NO NO NO YES
Ni100 NO NO NO YES NO NO NO YES
Ni1000 NO NO NO YES NO NO NO YES
NTC thermistor NO NO NO NO NO YES NO NO
PTC thermistor NO NO NO NO NO YES NO NO
PTC thermistor
(threshold)
NO NO NO NO NO YES NO NO
Resistance
measurement
NO NO NO NO NO YES NO NO
Expansion 0 to 20 mA NO NO YES NO NO NO NO NO
Expansion 4 to 20 mA NO NO YES NO NO NO NO NO