IDEC MICRO/I HG1P-ST32 Series User Manual

WindO/I-NV4 User’s Manual 31-23
2 USB Autorun Function
31
External Memory Devices
● Uploading a project
Uploads the project used to operate the MICRO/I and saves it to a USB flash drive or an SD memory card
*1
.
When the upload is complete, the MICRO/I will reset and start over at the beginning of the project.
●
Downloading a PLC program (ZLD Project File)
Downloads a ZLD Project File(.zld) saved on a USB flash drive or an SD memory card
*1
to the PLC connected to the
MICRO/I.
●
Uploading a PLC program
Uploads the PLC program from the PLC connected to the MICRO/I and saves it as ZLD Project File(.zld) to a USB flash
drive or an SD memory card
*1
.
*1 HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F only
Save Upload
Computer
ZNV Project File
(.znv)
USB Autorun
definition file
(hgauto.ini)
SD memory card
USB flash drive
MICRO/I
Refer to Chapter 29 “1 Project Transfer Function” on page 29-1 for important notes and limitations.
Save
Save
Download
PLC
Computer
SD memory card
USB flash drive
MICRO/I
ZLD Project File
(.zld)
ZLD Project File
(.zld)
USB Autorun
definition file
(hgauto.ini)
Refer to Chapter 29 “2 PLC Program Transfer Function” on page 29-16 for compatible PLCs, important notes,
and limitations.
Save Save Upload
PLC
Computer
ZLD Project File
(.zld)
USB Autorun
definition file
(hgauto.ini)
SD memory card
USB flash drive
MICRO/I
Refer to Chapter 29 “2 PLC Program Transfer Function” on page 29-16 for compatible PLCs, important notes,
and limitations.

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English