IDTECK iTDC - The Relation between Input and Output (3 Door Set-Up: Itdc Board Default)

p.118
APPENDIX
iTDC
[17] DURESS MODE 2 03 00 00 00 00 00 00
[18] DURESS MODE 3 00 00 03 00 00 00 00
[19] DURESS MODE 4 00 00 03 00 00 00 00
[20] OUTPUT Time Schedule 00 00 00 00 00 00 00
[21] INPUT Time Schedule 00 00 00 00 00 00 00
[22] INPUT Type 01 01 01 01 01 01 01
[23] DR TIME OUT 1 00 00 00 00 00 00 00
[24] DR TIME OUT 2 00 00 00 00 00 00 00
[25] DR TIME OUT 3 00 00 00 00 00 00 00
[26] DR TIME OUT 4 00 00 00 00 00 00 00
Index No Relay#1 Relay#2 Relay#3 Relay#4 TTL#1 TTL#2 TTL#3
Default output values of EIO88 Relay#1 ~ Relay#8 are all “00”.
INPUT Type: “00”= NC, “01”= NO
DR TIME OUT 1~4 (Door Time Out 1~4): It is interval time between door opening and closing
when door opening time is over.
1.2 The relation between input and output (3Door set-up: iTDC board default)
Index No Relay#1 Relay#2 Relay#3 Relay#4 TTL#1 TTL#2 TTL#3
[1] Input #1 (Door1 Exit button) 03 00 00 00 00 00 00
[2] Input #2 (Door1 Contact SW) 00 03 00 00 00 00 00
[3] Input #3 00 00 03 00 00 00 00
[4] Input #4 00 00 00 03 00 00 00
[5] Input #5 00 00 00 00 00 00 00
[6] Input #6 00 00 00 00 00 00 00
[7] Input #7 00 00 00 00 00 00 00
[8] EIO88 Input #1 (Door2 Exit) 00 00 00 00 00 00 00
[9] EIO88 Input #2 (Door2
Contact)
00 00 00 00 00 00 00
[10] EIO88 Input #3 (Door3 Exit) 00 00 00 00 00 00 00
[11] EIO88 Input #4 (Door3
Contact)
00 00 00 00 00 00 00
[12] EIO88 Input #5 00 00 00 00 00 00 00
[13] EIO88 Input #6 00 00 00 00 00 00 00
[14] EIO88 Input #7 00 00 00 00 00 00 00