IDTECK iTDC - 3-Door Control

PRODUCT INSTALLATION
iTDC
p.43
7.2 3-Door control
Firstly equip I/O board (EIO88) to iTDC/iTDC-SR then wire. Door 1 is controlled by main board
of iTDC/iTDC-SR and door 2, 3 are controlled by I/O board (EIO88).
Door 1 Door Lock
Connect to RL1 port of iTDC/iTDC-SR main board.
(Check the wiring type between POWER FAIL SAFE and POWER
FAIL SECURE)
Alarm
Connect to RL2 port of iTDC/iTDC-SR main board.
Door 2 Door Lock
Connect to OUT1 port of EIO88
(Check the wiring type between POWER FAIL SAFE and POWER
FAIL SECURE)
Alarm
Connect to OUT2 port of EIO88
Door 3 Door Lock
Connect to OUT3 port of EIO88 (Check the wiring type between
POWER FAIL SAFE and POWER FAIL SECURE)
Alarm
Connect OUT4 port of EIO88.
7.3 4-Door Control
Firstly equip I/O board (EIO88) to iTDC/iTDC-SR then wire. Door 1 and 2 are controlled by
main board of iTDC/iTDC-SR and door 3 and 4 are controlled by I/O board (EIO88).
Door 1 Door Lock
Connect to RL1 port of iTDC/iTDC-SR main board.
(Check the wiring type between POWER FAIL SAFE and POWER
FAIL SECURE)
Alarm
Connect to RL2 port of iTDC/iTDC-SR main board.
Door 2 Door Lock
Connect to RL3 port of iTDC/iTDC-SR main board.
(Check the wiring type between POWER FAIL SAFE and POWER
FAIL SECURE)
Alarm
Connect to RL4 port of iTDC/iTDC-SR main board.
Door 3 Door Lock
Connect to OUT1 port of EIO88
(Check the wiring type between POWER FAIL SAFE and POWER
FAIL SECURE)
Alarm
Connect to OUT2 port of EIO88
Door 4 Door Lock
Connect to OUT3 port of EIO88
(Check the wiring type between POWER FAIL SAFE and POWER
FAIL SECURE)
Alarm
Connect to OUT4 port of EIO88