IDTECK iTDC - Page 16

FEATURES
iTDC
p.9
Each time schedule code can have one different (or same) code respectively for
holiday.
Time schedule can be applied to the 4 functions below.
A. Card Time Schedule
This function allows access or prohibit in fixed time. From card registration, card
time schedule can be set to each of reader. It allows access in the appointed time
schedule time range and blocks in out of the range then time schedule errors are
stored.
B. Reader Time Schedule
If the reader mode is set as RF + PW(Password), the reader let card holders access
on the fixed time by only RF card but the reader becomes RF+PW(Password) mode
in out of the fixed time.
C. Output Time Schedule
Input the time schedule code to use in terms of each of output port. Signal outputs
in appointed time range.
D. Input Time Schedule
Operating for input time schedule is different depending on firmware version so
please check your firmware version carefully then follow the description below.
- Firmware Version 7.1.0 and lower iTDC/iTDC-SR: Input the time schedule code to
use in terms of each of input port. Input signal generates in out of appointed time
range.
- Firmware Version 7.2.0, 7.3.0 of iTDC/iTDC-SR: Input the time schedule code to
use in terms of each of input port. Input signal generates in appointed time range.
- Firmware Version 8.0.0 and higher iTDC/iTDC-SR: Input the time schedule code to
use in terms of each of input port. Input signal generates in or out of appointed
time range by using software.
(STARWATCH iTDC PRO I/II: Operating out of appointed time range STARWATCH
STANDARD: Operating in appointed time range)