Page 126 Setup Manual
D.6.1.9 Delete White Balance Data
The white balance data, measured with the white balance function, will be deleted.
Picture 110: Information about deleting the white balance data
Delete White Balance Data Click at the button to execute the deletion.
D.6.1.10 Brightness Correction
The brightness correction function does not perform any measurements; it only allows
setting a correction factor for the brightness. The interval of the correction factor is ± 2 dB.
Picture 111: Brightness Correction factor list
Click on the selection arrow to set the desired correction factor.
The correction factor will be effective immediately.
To Next Page
Loading...
Need help?
General
