Setup Manual Page 37
C.4 IP Address
Picture 14: IP Address mask
To set the parameter of IP address, gateway, and netmask, touch the number in the in the
respective line.
Touch the desired position in the respective row to move the cursor to that position.
To delete a digit, place the cursor right beside of the digit and press the “<=” button. It will
always be deleted from right to left.
Use the numeric keypad in order to enter digits.
Set network settings Saves the new or modified values when pressed.
Reset to Factory Resets all network parameters to factory default settings.
Reset network settings Resets all network parameters to previously defined value
when pressed. Chapter D.8.1 describes how to save the
parameters.
The section beside the numeric keypad shows device information.
If a WLAN module is installed in the scanner, the name and the IP address will be
displayed right beside the numeric keypad.
The device type with its complete serial number and the firmware version are displayed
below the WLAN information.
To Next Page
Loading...
Need help?
General
