Setup Manual Page 69
D.4.2.9 Wireless LAN (DHCP)
Use the function Wireless LAN (DHCP) to define the range of IP addresses that can be
used by the WLAN module for DHCP access.
Note: This menu is displayed only if a WLAN module is installed and if the settings for
IPv4 (Network Interface 1) and Wireless LAN (LAN Interface) fit together.
Picture 48: Wireless LAN (DHCP)
Click in the corresponding fields and enter the start IP address and the end IP address to
define the address range that can be used.
To Next Page
Loading...
