Image Access Bookeye 4 Setup Manual

Setup Manual Page 79
D.4.6.1 Exclusion of Wildcard Characters for Jobmode Scanning
Please note: Valid for firmware before V 6.08.
The number of variables which can be used for creating file names while scanning in
jobmode is limited.
When scanning in jobmode, the information for some variables is taken from the last
scanned image and is used for naming the selected images respectively the ZIP archive
file.
Picture 59 shows a part of the list of variables. The arrows mark the variables which
should not be used in jobmode.
Picture 59: Excluded wildcard characters
The information contained in the file name is only valid for the last image but not for the
images in a ZIP archive.
This limitation affects the settings in the following chapters:
D.4.6.3 FTP Server
D.4.6.4 Mail Server
D.4.6.5 SMB Configuration
D.4.6.6 Web Service Configuration
D.4.6.7 USB Device Configuration

Image Access Bookeye 4 Specifications

General

Brand	Image Access
Model	Bookeye 4
Category	Scanner
Language	English