EasyManuals Logo

Image Access Bookeye 4 Setup Manual

Image Access Bookeye 4
149 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
Page 62 Setup Manual
D.4.2.3 IPv4 (Network Interface 1)
The function IPv4 (Network Interface 1) allows the operator modifying the parameters for
the “Network Interface 1”. This is the secondary network and used for communication with
internal network devices, e.g. the WLAN module.
Picture 42: Settings of IPv4 (Network Interface 1)
The screen shows the parameters for the “Network Interface 1”.
The IP address 10.0.0.50 is pre-configured for the communication with the WLAN module.
Default IP address of the WLAN module: 10.0.0.1.
IP address
Enter the IP address for the “Network Interface 1”.
Subnet Mask
Enter the value for the subnet mask.
Default Gateway
Enter the value for the gateway.
After modifying the network parameters, click on the Apply button to transfer the new
settings to the scanner. The “Network Interface 1” is now accessible with its new IP
address.
Note: Depending on the browser used, it is necessary to delete the browser cache
before the scanner is accessible.

Table of Contents

Other manuals for Image Access Bookeye 4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Image Access Bookeye 4 and is the answer not in the manual?

Image Access Bookeye 4 Specifications

General IconGeneral
BrandImage Access
ModelBookeye 4
CategoryScanner
LanguageEnglish

Related product manuals