Setup Manual Page 61
D.4.2.2 IPv4 (Network Interface 0)
The function IPv4 (Network Interface 0) allows the operator modifying the parameters for
the “Network Interface 0”. This is the primary network and is used for communication with
external network devices.
Picture 41: Settings of IPv4 (Network Interface 0)
The screen shows the parameters for “Network Interface 0”.
Enter the IP address which should be used by the scanner.
Enter the value for the subnet mask.
Enter the value for the gateway. In most cases this is the IP
address of the scanner.
After modifying the network parameters, click on the Apply button to transfer the new
settings to the scanner. The scanner is now accessible with its new IP address.
Note: After changing the IP address the connection to the scanner gets lost. Enter the
new IP address in your browser to get re-connected with the scanner.
Depending on the browser used, it is necessary to delete the browser cache
before the scanner is accessible.
To Next Page
Loading...
