31.8.4 OMNI II Log Files Upload
In order to send log files to the server you must be connected to Internet and
provide same information as above.
This operation shall be performed only when the OMNI Smart Programmer is
operating in Clinical Mode.
31.8.5 OMNI II Log Files Download
In order to receive log files from the server you must be connected to Internet and
provide same information as above
This operation shall be performed only when the OMNI Smart Programmer is
operating in Remote Mode.
32. BLUETOOTH PRINTER
32.1 Description
The Zebra Bluetooth printer (optional accessory) consists of the following components:
• Zebra Printer (with installed rechargeable battery)
• Printer paper roll
• AC Adapter
32.2 Printer Charging
The Zebra printer may need to be charged before use.
To charge the battery in the Zebra printer:
Note: The Printer should only be charged (connected to its mains-powered charging
power supply) when outside of the patient environment.
• Open the port cover on the right side of the printer and plug in the DC output
connector of the AC Adapter into the power input connector of the printer.
• Plug in the printer’s AC Adapter to the mains to begin charging the internal
battery of the printer.
• When the printer’s battery is charging, the light on top of the printer (to the left of
the power button) will glow amber. When the printer’s battery is fully charged,
the light will turn green.
• When charging of the printer battery has been completed, unplug the DC output
connector of the AC Adapter from the power input connector of the printer.
To Next Page
Loading...