The Open and Save commands of the OMNI Smart Programmer software read
and write data from and to standard (.tip) files. As such, the OMNI Smart
Programmer software can also be used as an editor of standards (see Section 16).
11.2.3 Monitoring Tools
The OMNI Smart Programmer System offers a Programmer Interface with a
built-in electrocardiography channel. The patient’s ECG is displayed in the upper
portion of the OMNI Smart Programmer screen.
Warning: The displayed ECG is of monitoring quality and is not diagnostic
quality. Do not base clinical diagnostic decisions on the displayed
ECG. In particular, it is important to note that the chart gradient is not
the typical 25 or 50 mm/sec.
The OMNI Smart Programmer software can be used to set the OPTIMIZER
Smart IPG to Marker mode. “Markers” are flags that represent the various states
of the device and events detected during its operation. In this mode, all events
detected and generated by the OPTIMIZER Smart IPG are displayed in the ECG
window synchronized with the patient’s ECG signal.
• The OMNI Smart Programmer software keeps a log of all the interactions
that take place with the OPTIMIZER Smart IPG.
• Segments of the (marked) patient’s ECG can be recorded, and then easily
accessed using the Browse button (see Section 12.10.4).
• The OPTIMIZER Smart IPG keeps a record of all the events and
conditions that have occurred. These records can be downloaded from the
OPTIMIZER Smart IPG to the OMNI Smart Programmer, and the number
of occurrences of each event can be viewed on the Statistics bar of the
OMNI Smart Programmer software (see Section 25).
• The OMNI Smart Programmer software can be used to measure the
impedance of the LS and V leads (see Section 26).
11.2.4 Closing the Programmer Application
Clicking the “X” in the top right-hand corner of the OMNI Smart Programmer
software screen will close the application and return the programmer to the
selection screen.
To Next Page
Loading...