Impulse Dymanics OPTIMIZER Smart System - Numerical Codes; Numerical Code 0; Numerical Code 1; Numerical Code 2

99
34.6 Numerical Codes
The OPTIMIZER Mini Charger was designed to provide the patient with certain data and
warnings appropriate to the situation. If the charger detects a situation that requires
action, a code digit will appear on the “Call Doctor” Indicator. The following table
gives a description of each numerical code:
Numerical
Code
Description
Will Charging
Process Be
Discontinued?
0
IPG deactivated (see Section 33.6.1)
YES (see Note1,2)
1
Markedly changed lead impedance (see Section 33.6.2)
NO
2
Therapy suspended (see Section 33.6.3)
NO
3
No CCM therapy delivery programmed (see Section
33.6.4)
NO
4
CCM therapy rate low (see Section 33.6.5)
NO
5
High initial IPG temperature (see Section 33.6.6)
YES (see Note1,2)
6
Internal charger fault (see Section 33.6.7)
YES (see Note1)
7
Implant is not an OPTIMIZER Smart IPG (see Section
33.6.8)
YES (see Note1)
8
Problem related to profoundly discharged battery (see
Section 33.6.9)
YES (see Note1)
34.6.1 Numerical Code 0
When Numerical Code 0 is displayed, it means that the OPTIMIZER Smart IPG
has been deactivated and placed in Down mode. If this Numerical Code is
displayed by the charger, please contact your Impulse Dynamics representative.
34.6.2 Numerical Code 1
When Numerical Code 1 is displayed, it means that the OPTIMIZER Smart IPG
has detected a significant change in the impedance in one or both ventricular
leads. If this Numerical Code is displayed by the charger, please contact your
Impulse Dynamics representative.
34.6.3 Numerical Code 2
When Numerical Code 2 is displayed, it means that CCM therapy in the
OPTIMIZER Smart IPG has been suspended. If this Numerical Code is displayed
by the charger, please contact your Impulse Dynamics representative.
34.6.4 Numerical Code 3
When Numerical Code 3 is displayed, it means that CCM therapy has not been
programmed. If this Numerical Code is displayed by the charger, please contact
your Impulse Dynamics representative.
34.6.5 Numerical Code 4
When Numerical Code 4 is displayed, it means that the OPTIMIZER Smart IPG
has detected that the amount of CCM therapy delivered is below the alarm level
parameter programmed in the implanted device. If this Numerical Code is
displayed by the charger, please contact your Impulse Dynamics representative.