31.2.2 OMNI Smart Wireless Network Configuration Commands
The OMNI Smart Network configuration window provides the following
command buttons:
• Connect: connect to the selected wireless network. A password dialog
will appear in which you must enter the network key (ask the network
administrator for the key).
• Disconnect: disconnect from the selected wireless network.
• Refresh: refresh the connection status.
• Read configuration: read network configuration settings from a USB
drive. The USB drive must be provided by you network administrator or
Impulse Dynamics.
• Wired connection settings …: A TCP/IP Settings dialog window will
appear in which you must enter the TCP/IP settings (ask the network
administrator)
• Show MAC Addresses: A Network adapters MACs’ addresses dialog
window will appear detailing the MAC address of each network adapter
installed in the OMNI II Programmer Tablet PC.
• Close: closes the window.
31.3 OMNI Smart Operation Modes
31.3.1 OMNI Smart Startup Modes
The OMNI Smart Programmer software can be opened in one of the following
modes:
• 3-Lead Clinical Mode: for local operation in a clinical setting
o The OMNI II Programmer Tablet PC must be connected to the OMNI
II Programmer Interface Box using the Interface Box cable.
• 3-Lead Remote Mode: for remote operation of an OMNI Smart
Programmer in a clinical setting
o The OMNI II Programmer Tablet PC does not require an attached
interface. It still can monitor or control the device remotely via the
Internet (remote programmer, far from the patient).
• 2-Lead Clinical Mode: for local operation in a clinical setting
o The OMNI II Programmer Tablet PC must be connected to the OMNI
II Programmer Interface Box using the Interface Box cable.
• 2-Lead Remote Mode: for remote operation of an OMNI Smart
Programmer in a clinical setting
o The OMNI II Programmer Tablet PC does not require an attached
interface. It still can monitor or control the device remotely via the
Internet (remote programmer, far from the patient).
To Next Page
Loading...