Impulse Dymanics OPTIMIZER Smart System - Electromagnetic Interference Information (Table 1 of 6); Appendix II

110
APPENDIX II
Electromagnetic interference information (Table 1 of 6):
GUIDELINES AND MANUFACTURER’S DECLARATION – ELECTROMAGNETIC EMISSIONS
The OPTIMIZER Smart System (the OMNI Smart Programmer and the OPTIMIZER Mini Charger) is intended
for use in an electromagnetic environment as specified below. The customer or user of the OPTIMIZER Smart
System has to ensure that it is used in such an environment.
Emissions test
Compliance
Guideline – Electromagnetic environment
RF radiated emissions
as defined in
CISPR 11 2003
Group 1
Class A
In the OPTIMIZER Smart system, RF energy is exclusively
used for internal functions. RF emissions are therefore very
low and are not likely to interfere with electronic equipment
close by.
Conducted emissions as
defined in
CISPR 11 (not
applicable to OMNI
Smart)
Class A
Harmonic emissions as
defined in
IEC61000-3-2 (not
applicable to OMNI
Smart)
Class A
Voltage fluctuations
and flicker as defined in
IEC61000-3-3 (not
applicable to OMNI
Smart)
Class A