28.2 Setting the OPTIMIZER Smart IPG Real Time Clock
You can set the OPTIMIZER Smart IPG real-time clock either manually or by using the
computer’s clock. In both cases:
• Place (or replace, if necessary) the Programmer Wand over the OPTIMIZER
Smart IPG implant site.
• Select the Time button on the Tool Bar.
• When the Time window appears, select the Get Time button.
To manually set the current time of the OPTIMIZER Smart IPG:
• Select the new time in the Device current time box. The Set Time button will
start to blink, indicating that the current device time is different from the one
displayed in the screen.
• Select the Set Time button.
Caution: Be certain that you are selecting the correct button.
If the time change is successful, the Programmer will display the message “Set time
OK”.
If the Programmer Wand is not well positioned over the implant site, the interrogation
operation may fail. If a failure in communication occurs, the Programmer will display the
message “Set Time Error”, along with the options Retry and Cancel.
Retry can be performed by repositioning the Programmer Wand and selecting the Retry
button.
To set the current time of the OPTIMIZER Smart IPG to the computer’s time:
• Place (or replace, if necessary) the Programmer Wand over the OPTIMIZER
Smart IPG implant site.
• Select the Time button on the Tool Bar.
• When the Time window appears, select the Set with PC time button.
Caution: Be certain that you are selecting the correct button.
If the time change is successful, the Programmer will display the message “Set time
OK”.
If the Programmer Wand is not well positioned over the implant site, the interrogation
may fail. If a failure in communication occurs, the Programmer will display the message
“Set Time Error”, along with the options Retry and Cancel.
Retry can be performed by repositioning the Programmer Wand and selecting the Retry
button.
To Next Page
Loading...